TOP DEAD CENTER

 

 

GAP                      .075 INCH

 

 

TEST                     40 OHMS PIN 3 TO PIN 2 

                              OPEN PIN 3 TO SENSOR CASE 

                              OPEN PIN 1 TO CASE

 

 

STATIC                 LEAD MAGNET 1 DEGREE

 

 

 

 

BRACKET           RCD ENGINEERING BRACKET WORKS PERFECT

                                                           

 

                                                                                                                        THANKS

                                                                                                                        DAVE LEAHY 

NTO:

                              Best to ohm check pickup mounted on car in the bracket.

 

                              Do not over tighten bracket screw.  This may oval tubing and short pickup.

 

                              Run cables so to minimize vibration and strain.

 

                              Pickup must have clearance from blower pulley.

 

                              Keep all connectors clean and dry.  ( no connector grease! )